So you can just check the color of the antenna wire to know what color the learn button is. If you have the yellow or purple learn button, the antenna wire will match the learn button color. It can also be square-shaped and purple in color for some models.
This button is usually round and yellow for Chamberlain, Liftmaster, and Craftsman garage door openers. You should find the button on the side of the motor unit where the antenna wire hangs down. Once there, remove the lens cover to locate the learn button inside. You will need to remove the lens cover over the bulb on your motor unit to locate it.Ĭhamberlain garage door openers are typically an overhead installation, so climb a stepladder to reach the motor unit. The learn button is usually located on the back or side panel of the opener. You can further confirm the compatibility by checking the color of the learn button. The sensors are a security feature installed about 6 inches from the ground on the tracks on both sides of the garage door. One primary feature of these openers is the photoelectric sensors. Preliminary step: confirm you have the compatible remote controlĬhamberlain remote controls only work with garage door openers made in 1993 and after. Once you have all the supplies listed above, you can proceed to the steps below to complete reprogramming your opener. Light bulb (if the motor unit doesn’t already have one inside).Remote control (or multiple) to be programmed.Some garage door openers come with a control panel that can be used to program your remote control. The motor unit should also have a bulb that will flicker to indicate the system’s response to your input during programming.ĭepending on whether you will program the unit from the learn button on the motor unit or the control panel, you may need some or all of the following supplies. To program your Chamberlain garage door opener, you will need to start with the garage door closed.
CHAMBERLAIN KEYPAD PROGRAMMING HOW TO
0 kommentar(er)
